Configuring Isdn System Phones Remotely Via The External S Port On The Pbx (Externally) - Auerswald COMpact 5200 Advanced Information

Functions, Uses, Concepts
Remote Configuration and Alternative Connection Options
Configuring ISDN System Phones Remotely via the External S
Port on the PBX (Externally)
Requirements:
• PBX with internal ISDN system phones
• In the PBX configured remote switching number for system phones and
dealer access number (page Administration > Remote configu-
ration)
Note: If no dealer access number has been configured or the phone
number transmitted does not correspond with the configured phone
numbers, the PBX must be enabled via an internal phone using a digit
sequence for remote configuration.
• An existing external ISDN connection between the PC and the PBX
including the drivers
• Installed COMfortel Set configuration software version 3.0, or later
• Knowledge of the user, sub-admin or admin PIN
• Activation of the PBX immediately before remote configuration (see
section Short Reference) if no dealer access number has been
configured or the transmission of the configured numbers is not possible
on the computer being used
1. Start COMfortel Set.
2. Open Options > Interface....
3. Under Interface, select ISDN card (CAPI 2.0).
4. Click OK.
64
COMpact 5200/5200R/5500R - Firmware V7.2 - Advanced Information V04 07/2018
0