Configuring The Use Of The External Analogue Ports - Auerswald COMpact 5000 Operation Manual

Requirements:
• External S port (optional, see chapter Important Information > Product Details > Basic
0
Assembly and Extensions)
1. Open the page Hardware > Port configuration.
2. Select or clear the S0 bus monitoring check box.

Configuring the Use of the external analogue Ports

Proceed as follows:
• Using the configuration manager
Requirements:
• Selected COMpact 2FXO module
1. Open the page Hardware > Port configuration.
2. Under Use, select one of the following options:
free: Port is not used.
external: Port is used as external port.
Note:
If the settings for the module are marked in red, the module is selected but
not inserted.
The numbers under Port correspond to the numbers used on the board.
Further steps:
• If necessary, change the country-specific settings (see chapter Settings > Analogue
Connection > More Information on Country-specific Settings).
COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016
Configuring the Use of the external analogue Ports
Settings
Hardware
561