Configuring A Ringer Rhythm For Internal Calls; Configuring A Ringer Rhythm For External Calls Via The Analogue Connection - Auerswald COMpact 3000 analog Operating Manual

Settings
Ringer Rhythms

Configuring a Ringer Rhythm for Internal Calls

Configuring a Ringer Rhythm for Internal Calls
The ringtone indicates which tone sequence is used to signal internal calls on the analogue
PBX subscribers.
The configuration can be made as follows:
• Separately for subscribers
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorisation
– Expert view (click
– Analogue subscriber
1. Open the page PROPERTIES > Internal subscribers > Subscriber properties >
Analogue settings.
2. In the list field at the top, select the subscriber in question by his name or number.
3. Select one of the following options in the Ringtone for internal calls list field.
1 x long: 1 Long tone (1 second), 4 second pause, ...
3 x short: 3 Double tones, approx. 1 second pause, ...
Further steps:
– Save your settings before you leave the page.

Configuring a Ringer Rhythm for External Calls via the Analogue Connection

The ringtone indicates which tone sequence is being used to signal external calls, made to the
telephone number assigned to the analogue connection, on the internal PBX subscribers.
Note:
Signaling is carried out by analogue devices as described.
ISDN devices generate their own call tone/ringtone. For more information,
refer to the description of your ISDN end device.
The configuration can be made as follows:
486
)
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020