Table of Contents
Advertisement
Configuring ISDN System Phones Remotely via the External S
Port on the PBX (Externally)
Important: Before you can configure the system phones remotely, the
required configurations must first be made via an internal network
connection on the PBX.
Requirements:
•
PBX with internal ISDN system phones
•
In the PBX configured remote switching number for system phones and
dealer access number
– Using the Configuration Manager (page Administration > Remote
configuration)
Note: If no dealer access number has been configured or the phone
number transmitted does not correspond with the configured phone
numbers, the PBX must be enabled via an internal phone using a digit
sequence for remote configuration.
•
An existing external ISDN connection between the PC and the PBX (for
example over an ISDN PC controller at the external S
the complete installation of the drivers required for the device on the PC
•
Installed COMfortel Set configuration software version 3.0, or later
•
Knowledge of the user, sub-admin or admin PIN
•
Release of the PBX immediately before remote configuration (see
section Short Reference) if no dealer access number has been
configured or the transmission of the configured numbers is not possible
on the computer being used
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Remote Configuration and Alternative Connection Options
Functions, Uses, Concepts
port) including
0
0
65
Advertisement
Table of Contents
