Creating An Alarm; Creating A Switch Input And Assigning It To The Alarm - Auerswald COMpact 5000 Operation Manual

Pbx for analogue/isdn/internet telephony

Hide thumbs Also See for COMpact 5000:

Table of Contents

Creating an Alarm

The alarm must be created in the PBX and assigned an internal number to call and trigger it.

Proceed as follows:

• Using the configuration manager

1. Open the page Devices > Alarms.

3. Enter a new internal number in the Phone number entry field. Possible entries:

2 to 4 digits in the range of

Double allocation of a number is not possible.

Using phone numbers with few digits (two or three-digit numbers) inevitably

restricts the possible supply of phone numbers with more digits. For

example, if the phone number 12 is assigned, the phone numbers 120-129

and 1200-1299 are no longer available.

The default exchange line access number on the PBX is 0 in the factory

settings; however, this can be changed. Note that changing the exchange line

access number restricts the telephone numbering plan.

4. Enter a name for the alarm in the Name entry field.

Note: To create further configurations for an alarm, click Configure in the line

of the corresponding alarm. The configuration is described in the following.

An alarm can be assigned switch inputs that can be used to trigger the alarm.

COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016

Compact 5000r