Analogue End Devices; Connecting Analogue End Devices Directly To The Internal A/B Port - Auerswald COMpact 5000 Operation Manual

Analogue End Devices

This section describes the connection of different analogue end devices to the a/b port of a
COMpact 4FXS module. If at all possible, a difference is made between a device to be
connected directly and lines to be laid permanently.
Warning: Touching voltage-carrying conductors or telephone connections
can cause life-threatening electric shocks.
• The PBX contains hazardous voltages, even outside the power supply
• COMpact 5000: Pull out the power plug of the PBX before instructing a
Important: Improper use can cause, for example, functional restrictions or
interference, the destruction of the device or, in a worst-case scenario,
personal injury.
• Only connect equipment that is compatible with the proper use of the

Connecting Analogue End Devices Directly to the Internal a/b Port

Requirements:
• Inserted COMpact 4FXS module
• A commercially-available adapter to RJ-45, if necessary
• Minimal distance between the devices
Note: If the end device is placed a larger distance away from the PBX, the
cable and the wall sockets must be permanently installed.
1. Connect the end device to the telephone socket of the adapter, if necessary.
2. Connect the adapter to the RJ-45 socket that belongs to the internal a/b port.
COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016
unit (for instance ringer voltages). Work on active, contact-hazardous
parts is only permitted after creating a voltage-free state. Working close
to active parts is only permitted if these parts are voltage-free or are
protected against direct contact
qualified electrician to open the casing to install the expansion module or
perform switching or connecting services.
PBX.
Connecting Analogue End Devices Directly to the Internal a/b Port
Installation and Commissioning
Analogue End Devices
85