Table of Contents
Advertisement
18
Final Steps
Configuration of analog Devices
7
If you pick up the receiver telephone after having plugged in a new tel-
ephone, please dial
and hang up. Thanks to this the PBX will learn
the dialling mode.
If the new telephone has a dual-tone multifrequency dialling, check
whether the FLASH key was set and set the FLASH period as short as
possible (see operation instruction of the telephone). Then you execute
the programming described in the following. Subsequent to this the PBX
has learned the exact duration of the FLASH time of your telephone.
This is very important e.g. for the transfer or Query. Analog telephones
that execute certain function via T-Net function key/menu are using a
long FLASH (300 ms). Often an additional FLASH key is available. Con-
figure this also to 300 ms and execute the following programming again.
Learn Flash duration
b 7 Q 55 FF #
your DTMF
public
telephone
password
Configuration of ISDN Devices
You must inform each Auerswald system telephone and each ISDN
device (Euro-ISDN telephones, ISDN FAX machines, ISDN PC control-
lers etc.), about the internal telephone number it has to react on. For this
purpose you enter the telephone number (for example 27; see pic.
on
page
16) as 1st MSN into the device. How this does work can be
learned in the operation manuals of the corresponding devices.
Due to the free telephone numbering plan it is only clear after having fin-
ished the configuration which internal telephone number is available for
the corresponding internal S
port. If you like to enter telephone num-
0
bers into a couple of telephone numbers nevertheless in order to make
internal test calls before starting the configuration, simply use the inter-
nal telephone numbering plan created by pressing a button.
Please use each of these telephone numbers once. If one of these num-
bers is assigned twice, a proper functionality cannot be guaranteed any-
more.
Besides this make sure that this 1st MSN of the corresponding device
is also presented to the PBX.
You may also perform the terminal device test to check the numbers
(chapter Terminal Test on the internal S
Normally an ISDN subscriber is fixed to the internal S
was configured for. But if you activate in the configuration program
COMset that the ISDN subscribers may move from port to port, all the
ISDN devices will be allowed to be connected to any other internal S
port. The PBX recognizes the subscriber again and registers him to the
other port if the receiver is picked up for a short moment after plugging
into another ISDN wall jack. Also in this case the maximum quantity of
ISDN devices on one internal S
press the FLASH
key twice
Ports on page
55).
0
port which he
0
port must not be exceeded.
0
Final Steps
PBX Software Update
If you like to make sure that the PBX has the most current operation
software, you can execute an automatic PBX software update now (see
chapter Automatic PBX Software Update on page
Close the Case
If you finished the installation and put the cable properly into the cable
space you can close the cover. Insert the cover of the connection area
at the top into the cabinet and press the bottom down until it clicks into
position.
0
55).
Hide quick links:
Advertisement
Table of Contents
