Analogue Terminals At The Analogue Port - Auerswald COMpact 5000 Instructions Manual

Installation
• Existing network (LAN) or single switch (for VoIP terminals) with a data transmission rate
of 100 Mbit/s
Notes: For VoIP data communication in combination with the transmission of limited
amounts of data, a data transmission rate in the LAN of 10 Mbps is sufficient under certain
circumstances. For VoIP data communication in combination with the transmission of large
amounts of data (e. g. downloads), we recommend upgrading to a data transmission rate of
100 Mbps. For this purpose, replace not only all of the active network components (e. g.
switch and router), but also all of the passive network components (e. g. cables and wall
sockets). For a reliable support of 100 Mbps, you need cables and wall sockets of at least
Category 5 (CAT 5).
When using a switch with PoE function, a separate power supply (e. g. via a power plug) is
not required for connected VoIP telephones, always provided they support PoE.
• For the use of DiffServ for prioritising language packages: DiffServ support of all active
network components available and enabled
• NAT traversal should be carried out either by the PBX or by a well-functioning SIP-aware
router
Note: If the router is not SIP aware, several of the ports on the router necessary for VoIP
data communication must be enabled (RTP port and SIP UDP ports) (port forwarding). A list
of the ports used in the PBX can be found in the Configuration Manager of the PBX under
Overviews > Ports.
Caution: Opening a port on the NAT router is a security risk.
• Take additional protection measures.
Important: If you want to integrate the PBX into an existing network, contact the responsible
system administrator. Making changes to an existing network can cause considerable
malfunctions.

Analogue Terminals at the Analogue Port

Connection possibilities:
• Analogue telephones
56
COMpact 5000/5000R - Firmware V6.8 - Instructions V04 04/2017