Configuring Isdn System Telephones Remotely Via The External S Port On The Pbx (Externally) - Auerswald COMpact 3000 analog Operating Manual

Service and Maintenance
Remote Configuration and Alternative Connection Options
Configuring ISDN System Telephones Remotely via the External S
Configuring ISDN System Telephones Remotely via the External S
PBX (Externally)
Important: Before you can configure the system telephones remotely, the
required configurations must first be made via an internal network connection
on the PBX.
Requirements:
– External S port (only COMpact 3000 ISDN or COMpact ISDN module available as an option)
0
– Configured remote switching number for system telephones
Note: If no remote switching number for system telephones has been
configured, the PBX must be activated for remote configuration using a digit
sequence on an internal telephone. After this, the PBX is accessible over
each associated MSN/DDI.
– Configured dealer access number
Note: If no dealer access number has been configured or the telephone
number transmitted does not correspond with the configured telephone
numbers, the PBX must be activated via an internal telephone using a digit
sequence for remote configuration.
– Installed COMfortel Set configuration software as of version 2.5
– Knowledge of the user, sub-admin or admin PIN
– An existing external ISDN connection between the PC and the PBX over an Auerswald USB
device (e.g., COMfortel 2500) or an ISDN PC controller including the complete installation of
the drivers required for the device on the PC
Note: For an Auerswald USB device, this refers to the USB, the CAPI-2.0
and CoNDIS-WAN drivers. To install the drivers, refer to the driver installation
and Internet access instructions (CAPI/TAPI) that came with the device.
– Release of the PBX immediately before remote configuration if no dealer access number has
been configured or the transmission of the configured numbers is not possible on the
computer being used
1. Start the COMfortel Set configuration software.
2. Open the menu Options > Interface....
542
Port on the PBX (Externally)
0
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
Port on the
0