Table of Contents
Advertisement
50
Announcements via Loudspeaker and System Telephones
Change private Password
b 7 Q 38 V
your
public
telephone
password
The digit „0" is not allowed in the password. If the password
needs to be shorter than 4 digits, the remaining unused digits
will have to be filled with „0" during programming. Example: You like to
67
use the password
. You have to enter as „new password"
When telephoning later, you only need to enter
Start external Call with Project Assignment
b f (**) 96 p
internal
(for Direct
dial
Exchange Line
tone
Telephone only)
With the configuration software COMset can be configured how
many digits a project number will have (2-6 digits; 2 in the
default factory settings).
Announcement/handsfree operation (InterCom) via system tele-
phone: (only in combination with the system telephones COMfortel
1500/2500 and COMfort 1000/1200/2000 plus as well as smar-tel-i on
COMmander Basic) This function enables an announcement to a sys-
tem telephone from any available internal telephone without actively
taking the call at the target telephone (e.g. in a doctor's office).
Besides this you can instruct a system telephone to switch on the micro-
phone in addition to the loudspeaker (handsfree operation) so that a
person nearby can talk to you via the built-in intercom.
The InterCom function must be permitted on the called system tele-
phone (see manual of the telephone).
Call an internal System Telephone via InterCom Function (Announcement/handsfree Operation)
b f (**)
internal
(for Direct Exchange
dial tone
Line Telephone only)
0000
old private password (default:
no password; so enter
67
as a password.
project
number
2- to 6-digit
Announcements via Loudspeaker and System Telephones
660 n
661
or
V V #
new
repeat new
)
password
password
If you do not like your password to be compromised, you better avoid
assigning the password to a target dial key. If you have a display in the
telephone, you should perform the following procedure after program-
6700
.
ming: Take the receiver, dial a random digit and replace the receiver.
This way, you avoid to store your password in the redial memory that
anybody can retrieve in your absence.
0 r
Exchange Line Access Number
and external telephone number
Z r
or
Exchange Line Access Number
for the 1st to 4th S
port and
0
external telephone number
k
or
number of the Short-Code Dial
Number memory
Announcement via loudspeaker: (only in combination with a door/
switch module COMmander 2TSM analog) This function enables an
announcement to a loudspeaker device or an active loudspeaker (e.g.
ELA system in a department store or supermarket) connected to the
audio output (Cinch jack marked with „audio output") of the PBX. A pre-
viously configured internal telephone number is called from an internal
telephone. The voice connection is established right after dialling the
telephone number.
The internal number used here must be configured in COMset. Internal
subscribers need to have the announcement authorization.
g
internal telephone number
announcement/
of the system telephone
handsfree operation
Enter new private password
g
Start call with a project number
conversation
Start call via 1st to 4th exchange
line with a project number
(COMpact 4410 USB and
COMmander Basic only)
Start call via Short-Code Dial
Number with a project number
Call system telephone for
Call system telephone for
announcement
handsfree operation
Advertisement
Table of Contents
