Programming Subscriber Call Forwarding Via An External Telephone If You Are „Out Of Office - Auerswald COMpact 2206 USB Operator's Manual

Programming Subscriber Call Forwarding via an external Telephone if you are „Out of Office"
b M
external remote switching and
telephone programming MSN/DDI
12
„CF unconditional"
(for „CF on busy" 13 instead of 12 and
for „CF on no Reply" 14 instead of 12)
12
„CF unconditional"
(for „CF on busy" 13 instead of 12 and
for „CF on no Reply" 14 instead of 12)
12
„CF unconditional"
(for „CF on busy" 13 instead of 12 and
for „CF on no Reply" 14 instead of 12)
20 n
internal number of the
forwarded telephone
You are in need of an analog DTMF telephone, an ISDN tele-
phone with DTMF signalling or a DTMF sender.
The PBX has to be configured correspondingly with the configuration
program COMset.
You must have knowledge of the remote switching and programming
MSN/DDI and the external password programmed with the configura-
tion program COMset.
If you have started the programming as described here by calling the
PBX and enter the correct external password, you will hear the external
f 7 W f
tone continue external
(1 sec) with DTMF password
1 n
internal number of
the target telephone
0r
or
Exchange Line
Access Number and
external number of
the target telephone
k
or
Short-Code Dial
Number of the
target telephone
1 * n
star and internal number of the
telephone to be forwarded
0 * n
star and internal number of the
telephone to be forwarded
# f
external
acknowledgement
tone (1 sec
continuous tone)
external acknowledgement tone
(1 sec continuous tone)
*n # f
star and internal external
number of the tel- acknowledgement
ephone to be for- tone (1 sec
warded continuous tone)
# f
external
acknowledgement
tone (1 sec
continuous tone)
# f
external
acknowledgement
tone (1 sec
continuous tone)
Switch off all active subscriber Call Forwarding settings tor
acknowledgement tone. Then you can configure all the subscriber Call
Forwarding settings. After successful programming you will hear the
external acknowledgement tone again and may hang up or make fur-
ther setting.
If you are waiting too long with the code input or enter a wrong code,
you will hear a busy tone. In this case please hang up the receiver and
try again.
Settings
Start external Programming
Switch on subscriber Call
Forwarding with entry of an
internal subscriber telephone
number as destination
Switch on subscriber Call
Forwarding with entry of an
external telephone number as
destination
Switch on subscriber Call
Forwarding with entry of a
Short-Code Dial Number as
destination
Switch on subscriber Call
Forwarding without entry of a
telephone number because number
has already been saved
Switch off subscriber Call
Forwarding
this phone
27