Table of Contents
Advertisement
28
Description of the COMmander 2TSM analog Module (not enclosed)
In case that not all door bell button inputs are necessary in connection
with a door terminal, the inputs can be reconfigured to alarm contacts.
Alternatively to the existing internal Music on Hold you have a cinch
connector (mono) on the controller for feeding in external Music on Hold
or text announcements.
The level of the recorded NF signal can be adjusted with a trimmer on
the controller.
With this connector also a new internal Music on Hold can be recorded.
Uses for the 12 Volt Power Supply
The
12
volt
operation
voltage
that
is
available
on
the
COMmander 2TSM analog module is limited to app. 100 mA per door
terminal. So it can be used e.g. for supplying the door terminal systems
(if you use the TFS-2616 by Auerswald) or the door bell button inputs.
If the operation voltage is used for supplying the door terminal system,
it can be switched with a jumper plug to the relay contact TS12 (or TS22
for door terminal 2) (see
Pic.
35). If the operation voltage is not used for
supplying the door terminal system, the jumper plug must be removed
or inserted as demonstrated in
Pic.
36.
The 12 Volt operation voltage can also be sourced alternatively from the
connection clamp „+12Volt".
Pic. 35: Operation voltage available
The Volume Control for the external Music on Hold
You can adjust the volume of the external Music on Hold with the trim-
mer on the module next to the cinch connector.
The Status LEDs
The six Light-Emitting Diodes on the module circuit board display the
activation status of the six relays.
LED switched on:Relay is switched on
LED switched off:Relay is switched off
Pic. 36: Operation voltage switched off
Advertisement
Table of Contents
