Configuring Hold Time - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Configuring and Operating Functions
Call Parking

Configuring Hold Time

Configuring Hold Time
The hold time indicates how many minutes a call is kept in the internal parking zone at most.
After the hold time has elapsed, the subscriber that put the call in the parking zone is again
signaled that the call is still there. If this subscriber is busy, the call is put back on hold in the
parking zone. If the hold time elapses a second time without the call being transferred, the
connection is disconnected and the caller hears the busy tone.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorization
1. Open the page FUNCTIONS > Call parking.
2. Enter a value in the Hold time entry field. The following entries are possible:
1 to 20: A call is held for a maximum of 1 to 20 minutes in the internal parking
zone.
Further steps:
– Save your settings before you leave the page.
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
211