Table of Contents
Advertisement
Commissioning
Requirements
– A PC with the following features:
Intel Pentium 1 GHz or compatible processor
Windows XP (as of Service Pack 3), Windows
Vista 32-/64-Bit (as of Service Pack 2), Windows 7
32-/64-Bit, Mac OS X (as of 10.4), Linux (as of
Kernel 2.6)
Memory RAM: 256 MB, recommended 512 MB;
for Windows Vista/7: 1024 MB, for 64-bit 2048 MB
Browser for the configuration: Recommended
browsers: Microsoft Internet Explorer as of version
7.0, Mozilla Firefox as of version 3.0, Safari as of
version 5.0
Network card (the computer must be equipped
with a network card and the required driver
installed)
Transmission Control Protocol /Internet Protocol
CD-ROM or DVD drive
Mouse or compatible pointing device
SVGA graphics card with a resolution of 1024 x
768, recommended 1280 x 1024, and 65536
colours (16 bit)
– Existing Ethernet connection between the computer
and the PBX. See
Page
– Computer and PBX on the same network
Note: The PBX is delivered with the following default
network settings:
IP address
192. 168. 0. 240
Subnet mask
255. 255. 255. 0
Gateway
0. 0. 0. 0
DHCP client
Disabled
– Configuration of a static IP address on the computer,
if the computer should be connected directly to the
PBX. See
Page
58. If the Ethernet configuration on
the PBX delivered from the factory has not been
changed, the following IP addresses are available:
192. 168. 0. 1 to 192. 168. 0. 254
except for 192. 168. 0. 240 (IP address of the
PBX)
– Changing the Ethernet configuration of the PBX if
changes to the settings on the computer are not pos-
sible or you would like to integrate the PBX into an
existing network. See
are possible:
Configure a permanent IP address, subnet mask
and gateway address
Configure the PBX as the DHCP client that
receives its IP address from a DHCP server
(computer or router)
Important: Please contact the responsible system
administrator and configure the settings according to
his instructions.
56
Configuring the PBX via the Ethernet Port
59.
Page
58. The following options
Steps to Take
1.
Start a browser (for example, Mozilla Firefox).
2.
Enter http:// and the IP address of the PBX in the
address field of the browser.
Important: In the case of some browsers, superflu-
ous zeroes may cause problems. For this reason, you
should not enter e.g. 192.168.021.002 instead of
192.168.21.2.
The browser settings are then checked.
The page for entering the basic settings opens.
Note: This page only appears during the initial
system set-up.
3.
Enter at least the admin PIN.
4.
Click Execute.
5.
Click Next.
The login window opens.
6.
Enter the user name admin.
7.
Enter the admin PIN.
8.
Click Login.
The configuration manager opens.
9.
Configure the settings you want.
Note: The PBX configuration manual (available as a
PDF on the accompanying Auerswald Mega Disk)
includes configuration instructions as well as a
detailed description of each feature on the PBX. It
also includes information about the hardware and
software requirements, about configuring the PBX as
well as using the features. Please refer to the Online
Help for additional information on the individual
settings. This can be accessed from any page in the
configuration manager by clicking the question mark
icon
.
Advertisement
Table of Contents
