Table of Contents
Advertisement
Command Reference Guide
ip rip receive version
Use the ip rip receive version command to configure the Routing Information Protocol (RIP) version the
unit accepts in all RIP packets received on the interface. Use the no form of this command to restore the
default value. Variations of this command include:
ip rip receive version 1
ip rip receive version 2
Syntax Description
1
2
Default Values
By default, all interfaces implement RIP version 1 (the default value for the version command).
Command History
Release 1.1
Release 8.1
Functional Notes
Use the ip rip receive version to specify a RIP version that will override the version (in the Router RIP)
configuration.
AOS only accepts one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures the ATM subinterface 1.1 to accept only RIP version 2 packets:
(config)#interface atm 1.1
(config-atm 1.1)#ip rip receive version 2
60000CRG0-35E
Accepts only received RIP version 1 packets on the interface.
Accepts only received RIP version 2 packets on the interface.
Command was introduced.
Asynchronous transfer mode (ATM) subinterface was added.
Copyright © 2012 ADTRAN, Inc.
ATM Subinterface Command Set
2017
Advertisement
Table of Contents
