Table of Contents
Advertisement
Command Reference Guide
snmp trap
Use the snmp trap command to enable all supported Simple Network Management Protocol (SNMP)
traps on the interface. Use the no form of this command to disable this trap.
Syntax Description
No subcommands.
Default Values
By default, all interfaces (except virtual Frame Relay interfaces and subinterfaces) have SNMP traps
enabled.
Command History
Release 1.1
Release 5.1
Release 6.1
Release 8.1
Release 16.1
Release 17.9
Usage Examples
The following example enables SNMP on the virtual ATM subinterface:
(config)#interface atm 1.1
(config-atm 1.1)#snmp trap
60000CRG0-35E
Command was introduced.
Command was expanded to include the Ethernet subinterfaces and Gigabit
Ethernet interfaces.
Command was expanded to include the port channel and virtual local area
network (VLAN) interfaces.
Command was expanded to the asynchronous transfer mode (ATM)
interface.
Command was expanded to the tunnel interface.
Command was expanded to the Frame Relay and the ATM subinterfaces.
Copyright © 2012 ADTRAN, Inc.
ATM Subinterface Command Set
2033
Advertisement
Table of Contents
