ADTRAN AOS Version R10.1.0 Command Reference Manual page 2018

Command Reference Guide
ip rip send version
Use the ip rip send version command to configure the Routing Information Protocol (RIP) version the
unit sends in all RIP packets transmitted on the interface. Use the no form of this command to restore the
default value. Variations of this command include:
ip rip send version 1
ip rip send version 2
Syntax Description
1
2
Default Values
By default, all interfaces transmit RIP version 1 (the default value for the version command).
Command History
Release 1.1
Release 8.1
Functional Notes
Use the ip rip send version to specify a RIP version that will override the version (in the Router RIP)
configuration.
AOS only transmits one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures the ATM subinterface 1.1 to transmit only RIP version 2 packets:
(config)#interface atm 1.1
(config-atm 1.1)#ip rip send version 2
60000CRG0-35E
Transmits only RIP version 1 packets on the interface.
Transmits only RIP version 2 packets on the interface.
Command was introduced.
Asynchronous transfer mode (ATM) subinterface was added.
Copyright © 2012 ADTRAN, Inc.
ATM Subinterface Command Set
2018