Table of Contents
Advertisement
36
Creating a Basic Configuration
Start the configuration software COMset by clicking on the corre-
sponding symbol on the desktop or via „Start ... program ... Auer-
swald ... COMset .... (It may be necessary to cancel the dialog „load
configuration" after the start.)
Select the interface in the menu under „options... interface".
If there is a connection via serial interface, select the correct V.24
COM port of the PC (e.g. COM 1).
If there is a connection via an ISDN PC-controller, select the option
„ISDN PC-controller (CAPI 2.0)".
If there is a connection via COMfort 2000 (Routing,
„ISDN PC-controller (CAPI 2.0)" or „USB".
If there is a connection via COMfort 1200 (Routing,
the „USB" option.
After the first power-up the configuration of the COMmander
Basic via CAPI (ISDN PC-controller or COMfort 2000) is pos-
sible only once. For further configuration an ISDN PC-control-
ler has to be configured as internal subscriber on the corresponding S
port (If the ISDN PC-controller does not present any MSN, the PBX will
automatically use this subscriber.)
The ISDN PC-controller may not be configured as „Direct Exchange
Line Telephone". On the corresponding S
allowed.
In case of an indirect connection of the PC to the terminal to be config-
ured (e.g. PC connection to the USB port of a COMfort 2000 to config-
ure the PBX), the transmission will be faster if the interface is set to
„ISDN controller (CAPI 2.0)" (using the B channel) instead of the selec-
tion „USB" (using the D channel).
Click on the top left button „New" to open a new configuration. In the
next dialog you select the device type to configure.
If you like to modify the internal telephone numbers assigned
by the default settings of your PBX, read the existing configu-
ration out of the PBX instead of opening a new configuration
(with the button „Open" and then „from PBX").
On the right side of the window five modules (in the slots A-E) are
displayed. The two modules enclosed in the default factory settings
have already been activated. (If you extended or modified the PBX
with a module, activate it with the right mouse key.)
Then you click with the left mouse key on the module icon -of the
(first) 4S
Module to display the configuration options of the mod-
0
ule´s S
ports.
0
In the column „type of use" you can select between internal or exter-
nal S
port. Here the settings have already been pre-selected to
0
match with the hardware in the default factory setting. (If you have
changed the port settings by modifying the jumpers on the control-
ler, you have to adjust these settings. If an external S
used at this time, please select „free" or „S
For the external S
ports the connection type is individually selecta-
0
ble. In the default factory settings „PTP connection" was selected
here. If you connected an external S
nection", you must select this type of connection. This
tion may be necessary for additional 4S
Creating a Basic Configuration
page
41), select
page
41), select
0
port programming must be
0
port is not
0
internal".)
0
port to an NT with „PTMP con-
0
configura-
modules.
0
Advertisement
Table of Contents
