Switching Automatic Pbx Time Updates Via Isdn For Missing Time On/Off - Auerswald COMpact 3000 analog Operating Manual

Settings
PBX Time

Switching Automatic PBX Time Updates via ISDN for Missing Time On/Off

Note:
The network provider usually transmits a time that is precise to the minute.
The time is updated at most once per hour.
Switching this on/off can be done as follows:
• Via the configuration manager
Requirements:
– External S port (only COMpact 3000 ISDN or COMpact ISDN module available as an option)
0
– Configuration manager, opened with sufficient authorisation
1. Open the page CONFIGURATION > PBX time.
2. Select or clear the After each ISDN call check box.
Enables automatic updating of the PBX time after each ISDN call.
Disables automatic updating of the PBX time after each ISDN call.
Further steps:
– Save your settings before you leave the page.
Switching Automatic PBX Time Updates via ISDN for Missing Time On/Off
If updating the PBX time for missing time is enabled, the PBX automatically initiates an ISDN
call using the connection configured.
Note:
The automatic call is initiated if a valid time or a valid date is missing in both
the PBX and in the connected system telephone.
During an outgoing external call, the network provider usually transmits a
time that is precise to the minute that is then used to set the PBX time.
Switching this on/off can be done as follows:
• Via the configuration manager
476
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020