Powering Down And Switching Off The Pbx - Auerswald COMmander 6000 Advanced Information

Functions, Uses, Concepts

Powering Down and Switching Off the PBX

Powering Down and Switching Off the
PBX
If it is necessary to separate the PBX from the electric current (pull the
power plug of the PBX out of the socket and also of the accessory
equipment where required), the PBX will first have to be powered down
properly.
The COMmander 6000R/6000RX (19" casing) can be switched off by
pressing the Power button at the front side of the casing. It is de-energised
after switching off. Therefore it is not necessary to unplug the power plug
from the wall socket.
The COMmander 6000 (casing variant for wall mounting) has no button for
switching off. Pull the power plug from the wall socket to de-energise the
device (e.g. to insert modules).
Proceed as follows for powering down and switching off the PBX:
Important: When shutting down the PBX, all of the connections to the
web server, all calls and all data services are terminated. Unsaved data
is lost.
• Immediate powering down.
– Using the Configuration Manager (page Administration > Firmware
update/restart)
– By pressing a key on the PBX
Note: The PBX is powered down immediately. All connected calls will be
disconnected.
90
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018