Message: Notification About Existing Messages; Remote: Information About Remote Access; Data: Information About The Usb Connection; Data/Power: Information After Reset - Auerswald COMpact 4410 USB Installation And Configuration Manual

Message: Notification about existing Messages

The LED „Message" shows whether messages (e. g. in your Voice Mail
Center 461) are received.
ISDN Message Remote Data
ready busy

Remote: Information about Remote Access

The LED „Remote" is on during any remote access to your PBX
(Remote programming).
ISDN Message Remote Data
ready busy

Data: Information about the USB Connection

The LED „Data" informs about the integrity of the data connection
between the USB interface and the PC and about the transport of data
across this interface.
Immediately after power-on it also informs about the status and success
of the initialisation (see chapter Data/Power: Information after Reset on
page 53).
ISDN Message Remote Data
ready busy
You have got a mes-
sage.
Power
There is a remote
access to your PBX.
Power
green
The communication via
USB is possible, that
means there is a con-
nection to a switched on
Power
PC with all necessary
drivers installed.
green
Data is transmitted via
USB interface.
orange
USB suspend mode;
(chapter Error Messages
for USB on page

Data/Power: Information after Reset

When switching on/resetting the data/status LED glows as a proof that
the PBX is initializing.
The power LED (hardware LED) shows that the PBX is connected to the
230 V mains.
After a reset (may last some seconds) the LED „Data" usually
stops glowing. If this is not the case and the LED glows/blinks
red, there was an error.
If you have a USB connection, the LED remains glowing after a Reset,
to give a feedback about the operation status. The LED „Data" displays
information about the USB connection instead (see
mation about the USB Connection on page 53
tion about the USB Connection on page
ISDN Message Remote Data
ready busy
62).
Service Functions, Problem Solving
chapter Data: Infor-
or chapter Data: Informa-
53)
The PBX is switched off.
Power
Plug into the 230 volt
mains.
red
1st phase:
Reset/Initialisation
(some seconds)
orange
2nd phase:
Reset/Initialisation
(some seconds)
The PBX is ready for
operation.
red
If the LED glows/blinks
red, there was an error.
53