Configuring The Ipv4 Subnet Mask; Configuring The Ipv4 Gateway - Auerswald COMpact 5000 Operation Manual

Pbx for analogue/isdn/internet telephony

Hide thumbs Also See for COMpact 5000:

Table of Contents

The dialogue for applying the setting appears.

3. Clicke of the following buttons:

Apply immediately: The IPv4 address is immediately applied and the PBX is

routed to the new IPv4 address. After the rerouting, you need to log in again.

Apply at restart: The IPv4 address is not applied until the next time the PBX is

Configuring the IPv4 Subnet Mask

Proceed as follows:

• Using the configuration manager

• Using a character string on the internal telephone (see section Short Reference)

Requirements:

• Disabled DHCP client

1. Open the page Administration > IP configuration.

2. In the Sub-network mask entry field under ETHERNET CONFIGURATION, enter

the subnet mask. Possible entries:

IPv4 address (e.g.: 255.255.255.0)

TProceed as follows:

• Using the configuration manager

• Using a character string on the internal telephone (see section Short Reference)

Requirements:

• Disabled DHCP client

COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016

Identification

Configuring the IPv4 Subnet Mask

Compact 5000r