Configuring The Subnet Mask - Auerswald COMpact 3000 analog Operating Manual

Settings
Identification

Configuring the Subnet Mask

12 digits (e.g.: for the IP address 192.168.0.240, enter 192168000240)
6. Dial #.
7. Hang up the receiver.
Querying the PBX IP Address via an Internal Telephone
Requirements:
– CLIP-enabled telephone
– CLIP function enabled in the PBX (display of the telephone numbers)
1. Pick up the receiver.
2. Dial ##8*941#.
3. Hang up the receiver.
You will get a call. The PBX IP address is shown on the telephone display.
Configuring the Subnet Mask
The Subnet mask can be configured as follows:
• Via the configuration manager
• Using a character string on the internal telephone
Configuring the Subnet Mask via the Configuration Manager
Requirements:
– Configuration manager, opened with sufficient authorisation
– Disabled DHCP client
1. Open the page CONFIGURATION > Server configuration > Network.
Note: The configuration is also provided during the quick configuration using
the configuration wizard.
346
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020