Switching Extended Clip Information On/Off - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Configuring and Operating Functions
Telephone Number Display (CLIP)

Switching Extended CLIP Information On/Off

Switching Extended CLIP Information On/Off
If extended CLIP information is enabled, the date and time on CLIP-capable analog telephones
is recorded in conjunction with their caller list. The PBX can make this information available so
that the date and time of previous calls are displayed in the caller list when scrolling. Some
analog telephones can also display CLIP information alpha-numerically. In this case, the PBX
compares the transmitted telephone number with the short-code numbers saved in the PBX. If
an identical telephone number is found, the name saved in the PBX is also displayed in addition
to the telephone number information.
Note: For some end devices, extended CLIP information can cause problems
and should therefore be disabled.
Switching this on/off can be done as follows:
• Separately for subscribers
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorization
– Expert view (click
– Analog subscriber
– Telephone number display (CLIP): CLIP info enabled for the subscriber
1. Open the page PROPERTIES > Internal subscribers > Subscriber properties >
Analog settings.
2. In the list field at the top, select the subscriber in question by his name or number.
3. Select or clear the Extended CLIP info check box under Telephone number display
(CLIP).
Enables extended CLIP information.
Disables extended CLIP information.
Further steps:
– Save your settings before you leave the page.
306
)
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11