Switching Extended Clip Information On/Off - Auerswald COMpact 3000 analog Operating Manual

Switching Extended CLIP Information On/Off

If extended CLIP information is enabled, the date and time on CLIP-capable analogue
telephones is recorded in conjunction with their caller list. The PBX can make this information
available so that the date and time of previous calls are displayed in the caller list when
scrolling. Some analogue telephones can also display CLIP information alpha-numerically. In
this case, the PBX compares the transmitted telephone number with the short-code numbers
saved in the PBX. If an identical telephone number is found, the name saved in the PBX is also
displayed in addition to the telephone number information.
Note: For some end devices, extended CLIP information can cause
problems and should therefore be disabled.
Switching this on/off can be done as follows:
• Separately for subscribers
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorisation
– Expert view (click
– Analogue subscriber
– Telephone number display (CLIP): CLIP info enabled for the subscriber
1. Open the page PROPERTIES > Internal subscribers > Subscriber properties >
Analogue settings.
2. In the list field at the top, select the subscriber in question by his name or number.
3. Select or clear the Extended CLIP info check box under Telephone number
display (CLIP).
Enables extended CLIP information.
Disables extended CLIP information.
Further steps:
– Save your settings before you leave the page.
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
)
Telephone Number Display (CLIP)
Switching Extended CLIP Information On/Off
Functions
293