Installing TAPI driver (TSP)
The PBX must be connected with a server PC via a TCP/IP network. The
TAPI driver (TSP) that belongs to the PBX must be installed on this server
PC from the Auerswald Mega Disk.
Important: If you want to integrate the LAN-TAPI into an existing
network, please contact the system administrator responsible for this.
Making changes to an existing network may cause considerable
functional disturbances.
Note: You can find the current version of the driver on the Internet (see
Auerswald: www.auerswald.de/service, FONtevo:
support.fontevo.com).
Requirements:
•
A driver file (*.exe) in its current version saved on a data storage device
(PC)
•
Server PC that fulfils one of the following minimum requirements:
- Windows 7 (32-/64-Bit)
- Windows Server 2008 und Windows Server 2008 R2
- Windows 8/8.1 (32-/64-Bit)
- Windows 10 (32-/64-Bit)
- Windows Server 2012 und Windows Server 2012 R2
- Windows Server 2016
1. Start driver file (*.exe) on the server PC.
The TAPI driver installation is started.
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Functions, Uses, Concepts
LAN-TAPI
121