Installing The Rndis Driver On Windows Xp; Putting Analogue End Devises Into Operation; Putting Isdn System Telephones Into Operation - Auerswald COMmander Basic.2 Installation And Commissioning Instructions

Commissioning
– The USB cable included in the delivery.
Steps to Take
1.
Insert the square USB cable connector into the USB
socket on the PBX.
2.
Close the PBX casing.
Requirements
– Auerswald Mega Disk (as of version 5.81)
Steps to Take
The hardware wizard will automatically start in
order to install the RNDIS driver for the device.
1.
Click No, not this time, and then click Next.
2.
Insert the Auerswald Mega Disk into the CD-ROM
drive.

Putting Analogue End Devises into Operation

Requirements
– The internal phone number configured on the a/b port
in question
– Earthed PBX (see Page 30

Putting ISDN System Telephones into Operation

Requirements
– The internal phone number configured on the S
in question
– Earthed PBX (see Page 30
Steps to Take
1.
Connect end devices with a separate power supply to
the 230 V mains.
2.
Select the language.
3.
Enter the internal phone number as an MSN for the
end device.
The end device is ready for operation.
60

Installing the RNDIS Driver on Windows XP

and Page 38)
port
0
and Page 38)
3.
Turn the PBX and the PC on.
4.
Insert the flat connector on one end of the USB cable
into a USB port on the computer.
Further Steps
Install the RNDIS driver for the device. See
for Windows XP.
3.
Click Install the
(Recommended), and then click Next.
A search is made for the driver to be installed. As
soon as the driver is found, you are asked
whether you would like to continue.
4.
If necessary, click Continue anyway.
The installation of the driver is resumed.
5.
Click Finish.
Steps to Take
1.
Connect end devices with a separate power supply to
the 230 V mains.
The end device is ready for operation.
Page 60
software automatically