Configuring The Billing Factor - Auerswald COMpact 3000 analog Operating Manual

Telephone Book and Lists
Call Data

Configuring the Billing Factor

The value entered here refers to the currency entered under Currency name (e.g., for the
Currency name EUR
Note: For Least Cost Routing (LCR), the tariff information of call-by-call-
providers is saved in the PBX. This data (prices + charge pulse interval)
replace the cost per call unit entered here for all LCR calls.
The configuration can be made as follows:
• Via the configuration manager
Requirements:
– Configuration manager, opened with a sufficient authority level
– External S port (only COMpact 3000 ISDN or COMpact ISDN module available as an option)
0
1. Open the page FUNCTIONS > Time and call allowance accounts > Settings.
2. Enter a value in the Cost per call unit entry field. The following entries are possible:
Price in 00.0000 format: Specifies the cost per call unit from 0.0000 to 99.9999.
Digits and the separator
Further steps:
– Save your settings before you leave the page.
Configuring the Billing Factor
The billing factor indicates the value used to convert the subscriber's telephone costs.
This factor is used to multiply the charges transmitted from the network provider or the calcu-
lated charges. The telephone costs calculated in this way are used in the call data list.
The configuration can be made as follows:
• Separately for subscribers
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorisation
– Expert view (click
148
0.0600 for 6 cents).
,
)
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020