Configuring The Cost Per Call Unit; Configuring The Billing Factor - Auerswald COMpact 5000 Operation Manual

Pbx for analogue/isdn/internet telephony

Hide thumbs Also See for COMpact 5000:

Table of Contents

Address Books and Lists

Configuring the Cost per Call Unit

The cost per call unit are used for internal calculations and the display.

The value entered here refers to the currency entered under Currency name (e.g., for the

Currency name

For Least Cost Routing (LCR), the tariff information of dial-around providers

is saved in the PBX. This data (prices + charge pulse interval) replace the

cost per call unit entered here for all LCR calls.

If using an analogue exchange line or a VoIP account for external calls, no

charges will be displayed.

Proceed as follows:

• Using the configuration manager

1. Open the page Functions > Call allowance accounts.

2. Enter a value in the Price per unit entry field. Possible entries:

Price in 00.0000 format: Specifies the cost per call unit from 0.0000 to 99.9999.

Digits and the separator

The billing factor indicates the value used to convert the subscriber's telephone costs.

This factor is used to multiply the charges transmitted from the network provider or the calcu-

lated charges. The telephone costs calculated in this way are used in the call data list.

Proceed as follows:

• Separately for subscribers

• Using the configuration manager

1. Open the page Subscribers (scr.) > Properties > Settings.

2. In the list field at the top, select the subscriber in question by his name or number.

0.0600 for 6 cents).

COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016

Compact 5000r