Internal U P0 Port; Internal Analogue Port - Auerswald COMpact 5000 Setup Manual

Important Information
Important: The power consumption of the end devices on an S
total a maximum of 4 W. A maximum of 40 W is available for all the a/b-,
S
0
Internal U
An internal U
that, for example, becomes useful if existing 2-core lines in an analogue instal-
lation are to be used. It is suitable for connecting to one of the following end
devices:
Other ISDN end devices can only be connected to the U
adapter. It provides a S
wire. It is suitable for connecting to the following terminal devices:
Important: The power consumption of the end devices on an S
total a maximum of 4 W. A maximum of 40 W is available for all the a/b-,
S
0

Internal Analogue Port

An internal analogue port (not included in the basic assembly) is suitable for
connecting to one of the following end devices:
Important: Devices using pulse dialling cannot use the full range of fea-
tures of the PBX, for example, transfer a call.
Devices using dual-tone multi-frequency dialling must be equipped with a
flash key (also referred to as signal key R).
60
- und U ports together.
P0
Port
P0
port (not included in the basic assembly) is a 2-core interface
P0
COMfortel 1200/1400 system telephones
COMfortel 1600/2600 system telephones (as of firmware version 1.2C)
COMfortel 1100/1500/2500/2500 AB system telephones (as of firmware
version 4.4I)
port with two RJ-45 sockets by converting 2-wire to 4-
0
COMfortel DECT 900 Bases for COMfortel DECT 900C/900
ISDN telephones in compliance with the Euro ISDN Standard (DSS1)
ISDN PC controllers in compliance with the Euro ISDN Standard (DSS1)
- und U ports together.
P0
Analogue telephones with DTMF dialling, e. g. COMfortel 600 or COM-
fortel DECT 660C
Analogue telephones with pulse dialling
Analogue fax machines
Analogue answering machines
Modems
COMpact 5000/R - Firmware Version 6.2 - Setup V01 03/2014
port may
0
port via a U /S
P0 P0
port may
0
0