Switching The Automatic Updating Of The Pbx Time On/Off Via The Network; Switching Automatic Updating Of The Pbx Time After Each Isdn Call On/Off - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Configuring and Managing the PBX
PBX Time

Switching the Automatic Updating of the PBX Time On/Off via the Network

Switching the Automatic Updating of the PBX Time On/Off via the Network
Switching this on/off can be done as follows:
• Via the configuration manager
Requirements:
– PBX connection to the server network
– Configuration manager, opened with sufficient authorization
1. Open the page CONFIGURATION > PBX time.
2. In the Update interval list field, select one of the following options:
no NTP service: Disables the automatic updating of the PBX time via the
network. (No other action is required.)
Time interval, e.g., Update after 5 hours: Enables the automatic updating on
the PBX time via the network.
Note: The automatic updating of the PBX time via the network is performed
at the selected time interval (e.g., every 5 hours).
3. Select or enter an NTP server:
• Click the Country option button and select the desired country from Country the
list field. Finally, select the desired server from the NTP server list field.
• Click the Manual server option button. Enter the address of a local NTP server or
the name of a external NTP server in the Manual server entry field.
Note: You should receive the address from the system administrator of the
network.
Further steps:
– Save your settings before you leave the page.

Switching Automatic Updating of the PBX Time after Each ISDN Call On/Off

If updating the PBX time after each ISDN call is enabled, the time transmitted by the network
provider during an outgoing external call is used for setting the PBX time.
460
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11