Switching Loop Current Detection At End Of Call On/Off; Switching Dtmf Code Detection At End Of Call On/Off - Auerswald COMpact 3000 analog Operating Manual

Settings
Analogue Connection

Switching Loop Current Detection at End of Call On/Off

Further steps:
– Save your settings before you leave the page.
Switching Loop Current Detection at End of Call On/Off
If loop current detection at the end of a call is enabled, a reduction of the loop current to zero
by the PBX network provider is interpreted as the end of the call.
Switching this on/off can be done as follows:
• Via the configuration manager
Requirements:
– External analogue port (only COMpact 3000 analogue)
– Network provider support for reducing the loop current at the end of a call
– Configuration manager, opened with sufficient authorisation
– Expert view (click
– Configured prefixes (country prefix and local area code)
1. Open the page CONFIGURATION > External numbers.
2. In the list field at the top, select the analogue connection.
A page opens for configuring the analogue connection.
3. Open the page Analogue connection > Expert configuration.
4. Select or clear the Loop current detection check box under End of the call.
Enables loop current detection.
Disables loop current detection.
Further steps:
– Save your settings before you leave the page.

Switching DTMF Code Detection at End of Call On/Off

If DTMF code detection is enabled, transmitting the DTMF code D via the PBX network provider
is interpreted as the end of the call.
390
)
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020