Identification Number - Auerswald COMpact 5000 Operation Manual

Pbx for analogue/isdn/internet telephony

Hide thumbs Also See for COMpact 5000:

Table of Contents

Relays (Actuators)

Identification Number

A relay used for this purpose can, for example, be part of a connected device (e. g. door

terminal, IP switch relay). The relay is created in the configuration of the PBX as part of this

device and is then assigned to a function by the selection of an operating mode. It then remains

part of the selected device in the configuration of the PBX.

Proceed as follows:

• Using the configuration manager

Requirements:

• Relay/actuator (optional, see chapter Important Information > Product Details > Basic

Assembly and Extensions)

• Created device (e. g. door terminal, IP switch relay) as whose part the relay is to be created

1. Open the page Devices > Relays (Actuators).

3. Enter a name for the relay in the Name entry field.

4. In the Add to list field, select the device as whose part the relay is to be created.

Note: To create further configurations for a relay, click

corresponding relay. The configuration is described in the following.

Identification Number

For manual switching of a relay by a programming sequence or remote switching the number

(2 to 4 digits) defined here is necessary.

Note: All previously assigned identification numbers can be viewed sorted by

number, name or type under Overviews > Identification number table.

COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016

in the line of the

Compact 5000r