Initiating Priority Call For Do-Not-Disturb - Auerswald COMpact 3000 analog Operating Manual

Telephoning
Outgoing Calls

Initiating Priority Call for Do-Not-Disturb

2. Dial *37#.
You will hear the confirmation tone.
Note: If you do not hear a confirmation tone, the callback request was
rejected by the central office.
3. Hang up the receiver.
As soon as the connection has been used, you are called by the central office for a
period of 20 seconds.
4. Pick up the receiver to the make the callback.
Note: If you do not pick up the receiver within the 20 seconds during which
the central office calls you, the callback request will be deleted.
If you pick up the receiver, the subscriber will be called.
Note: A callback will be stored in the central office for a duration of up to 45
minutes. If the called subscriber has not terminated his call until then, the
callback will automatically be deleted.
Important: To use this function at ISDN telephones and system telephones
or to delete it again, this function must be supported via a function key or via
the menu by the respective telephone (optional, see manual for the
telephone).
Initiating Priority Call for Do-Not-Disturb
If the internal telephone you are trying to call is busy because it is set to do-not-disturb, proceed
as described in the following.
• Wait ten seconds.
The subscriber is now called.
112
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020