Ip Rip Copy-To-Dynamic - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

ip rip copy-to-dynamic

[ no ] ip rip copy-to-dynamic
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Enables RIP on dynamic, unnumbered IP interfaces. You cannot configure RIP on
Description
dynamic interfaces directly. However, this command allows dynamic, unnumbered
interfaces (that refer to numbered IP interface for configuration data) to obtain RIP
attributes from the numbered IP interface to which they refer. The no version disables
the feature but does not remove all existing, active RIP interfaces that were created
by this command.
Interface Configuration
Mode
926
ip rip copy-to-dynamic