Ip Auto-Detect Ip-Subscriber - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

Chapter 10: I Commands

ip auto-detect ip-subscriber

[ no ] ip auto-detect ip-subscriber
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Sets the router's packet detect feature, specifying that IP automatically detect packets
Description
that do not match any entries in the demultiplexer table. When an unmatched packet
is detected, an event is generated that determines whether to create a dynamic
subscriber interface or to configure an existing interface. The no version disables
autodetection.
Interface Configuration, Profile Configuration
Mode
749
ip auto-detect ip-subscriber