Disable-Switch-On-Error - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

disable-switch-on-error

[ no ] disable-switch-on-error
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Prevents the redundant SRP module from taking over if the primary SRP module
Description
experiences a software failure or if you push the reset button on the primary SRP
module. Issue the sync command immediately before you issue this command. The
no version restores the default situation, in which the redundant SRP module takes
over if the primary SRP module experiences a failure.
Global Configuration
Mode
524
disable-switch-on-error