Mpls Traffic-Eng Area - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

mpls traffic-eng area

[ no ] mpls traffic-eng area { areaId | areaIdInt }
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Enables flooding of MPLS traffic-engineering link information into the specified OSPF
Description
area. Flooding is disabled by default. The no version disables flooding.
Options
Router Configuration
Mode
areaId OSPF area ID in IP address format
areaIdInt OSPF area ID as a decimal value in the range 0–4294967295
Chapter 13: M Commands
1427
mpls traffic-eng area