Ip Igmp Querier - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

ip igmp querier

[ no ] ip igmp querier
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies that the interface will act as a querier when you configure IGMPv1 on an
Description
interface; this is the default behavior. The no version specifies that this interface will
not issue query packets.
NOTE: This command is valid only for interfaces on configured with IGMPv1.
Interface Configuration, Profile Configuration
Mode
830
ip igmp querier