Ethernet Oam Lfm Remote-Loopback - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

ethernet oam lfm remote-loopback

ethernet oam lfm remote-loopback { start | stop } interfaceType interfaceSpecifier
Syntax
Command introduced in JUNOSe Release 11.1.0.
Release Information
Enables or disables remote loopback functionality on the remote OAM entity. Also
Description
causes the remote peer to commence or halt sending of all received frames from
the local entity to the specified interface, except OAM PDUs, without any changes
made to the frames. OAM PDUs continue to be processed. By default, the remote
peer does not loop back the non-OAM PDUs that it receives from the local entity.
There is no no version.
This configuration setting is not preserved across a reboot.
Options
Privileged Exec
Mode
Related Topics
594
ethernet oam lfm remote-loopback
start Commences the remote loopback operation on the remote OAM entity
stop Halts the remote loopback operation on the remote OAM entity; this is
the default behavior
interfaceType One of the following interface types listed in "Interface Types
and Specifiers" on page 5
fastEthernet
gigabitEthernet
tenGigabitEthernet
interfaceSpecifier—Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
OAM Remote and Local Loopback Feature
ethernet oam lfm remote-loopback supported on page 595
Configuring 802.3ah OAM Link-Fault Management
Example: Enabling Remote Loopback Support on the Local Interface