Frame-Relay Policy - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

frame-relay policy

frame-relay policy { input | output } policyName
Syntax
[ statistics { enabled [ baseline { enabled | disabled } ] [ preserve | merge ] |
disabled [ merge ] } | merge ]
no frame-relay policy { input | output } [ policyName ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
merge keyword added in JUNOSe Release 7.2.0.
Assigns a policy list to the ingress or egress of a Frame Relay interface. If you enter
Description
this command when the policy list does not exist, the router will create a policy list
with a filter rule as the default. You must specify the input or output keyword to
assign the policy list to the ingress or egress of the interface. The no version removes
the association between a policy list and an interface.
Options
Interface Configuration
Mode
Related Topics
656
frame-relay policy
input Applies policy to data arriving at this interface
output Applies policy to data leaving this interface
policyName Name of the policy; a maximum of 40 characters
statistics Enables or disable collection of policy routing statistics
enabled Enables collection of policy routing statistics
baseline enabled Enables baselining of policy routing statistics
baseline disabled Disables baselining of policy routing statistics
preserve Preserves existing statistics for any classifier-list that is the same
for both the new and old policy attachments when you attach a new policy
to an interface
disabled Disables collection of policy routing statistics
merge Enables merging of multiple policies to form a single policy
Setting a Statistics Baseline for Policies