Gre-Tunnel Policy - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

gre-tunnel policy

gre-tunnel policy { input | output } policyName
Syntax
[ statistics { enabled | disabled | preserve } | merge ]
no gre-tunnel policy { input | output } [ policyName ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
merge keyword added in JUNOSe Release 7.2.0.
Assigns a GRE tunnel policy list to an interface. If you enter the gre-tunnel policy
Description
command and the policy list does not exist, the router creates a policy list with no
rules, the default. Attaching this policy list to an interface filters all packets on that
interface. You must specify the input or output keyword to assign the policy list to
the ingress or egress of the interface. The no version removes the association between
a policy list and an interface.
Options
Interface Configuration
Mode
Related Topics
input Applies policy to data arriving at this interface
output Applies policy to data leaving this interface
policyName Name of the policy; a maximum of 40 characters
statistics Enables or disables collection of policy routing statistics
enabled Enables collection of policy routing statistics
disabled Disables collection of policy routing statistics
preserve Preserves existing statistics for any classifier-list that is the same
for both the new and old policy attachments when you attach a new policy
to an interface
merge Enables merging of multiple policies to form a single policy
Setting a Statistics Baseline for Policies
Chapter 8: G Commands
675
gre-tunnel policy