Mpls-Relay - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

mpls-relay

mpls-relay remoteIpAddress [ vc-id ] vcidValue [ group-id groupIdValue ]
Syntax
[ control-word | no-control-word ] [ sequencing | no-sequencing ]
[ relay-format { ethernet | frame-relay | ppp | vlan | ethernet-raw-mode } ]
no mpls-relay
Command introduced before JUNOSe Release 7.1.0.
Release Information
control-word, no-control-word, no-sequencing, and vlan keywords added in JUNOSe
Release 7.1.0.
frame-relay keyword added in JUNOSe Release 9.1.0.
ethernet-raw-mode keyword added in JUNOSe Release 10.0.0.
Routes layer 2 traffic to the specified router by creating an MPLS shim interface on
Description
the layer 2 interface. The router can use any MPLS LSP to the remote destination
address that you specify. You must issue this command in the virtual router where
the remote address can be reached; that is, in the virtual router providing core
connections. The no version removes the shim interface. See also the route interface
command.
NOTE: This command is supported for configuration on an ATM port (ATM Adaptation
Layer 5 [AAL5] over an ATM major interface). Before you can specify VPI/VCI ranges
and cell concatenation parameters on the ATM port to enable transmission of multiple
ATM virtual circuits over a single pseudowire, you must associate the ATM port with
the corresponding pseudowire using the mpls-relay or router interface tunnel
command. For more information about the support for multiple VCs over a single
pseudowire, see Multiple ATM Virtual Circuits over a Single Pseudowire Overview in
the JUNOSe BGP and MPLS Configuration Guide
Options
NOTE: The VLAN ID, DLCI, or ATM VPI/VCI are not related to the VC ID and can be
different on each end of the connection.
remoteIpAddress IP address of the router on the remote end of the layer 2 circuit
vcidValue Integer in the range 1–4294967295 that identifies the virtual
connection; the two ends across the MPLS core must match inside each VC type
groupIdValue Integer in the range 0–4294967295 that identifies a group of
virtual connections; not currently used
control-word Indicates that the local preference is to use the control word for
the layer 2 packets encapsulated in MPLS packets sent to the remote PE router.
The default preference is determined by the interface stack on which the MPLS
interface is stacked.
Chapter 13: M Commands
1395
mpls-relay