Ip Pim Rp-Candidate - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

ip pim rp-candidate

ip pim rp-candidate interfaceType interfaceSpecifier [ group-list accessListName ]
Syntax
[ hold-time holdTime ] [ priority priority ] [ interval interval ]
no ip pim rp-candidate interfaceType interfaceSpecifier
Command introduced before JUNOSe Release 7.1.0.
Release Information
Defines a router as a rendezvous point (RP) router candidate. The no version stops
Description
the router from being an RP candidate.
Options
Global Configuration
Mode
904
ip pim rp-candidate
interfaceType Interface type; see Interface Types and Specifiers on page 5
interfaceSpecifier—Particular interface; format varies according to interface type;
see "Interface Types and Specifiers" on page 5. The autoRP announcement
messages will contain the IP address for this interface.
accessListName Access list containing the set of group prefixes supported by
this C-RP. If no group-list is specified, the default value is the entire multicast
address range.
holdTime Amount of time in the range 1–65535 seconds that the BSR keeps
an RP in its C-RP list if the BSR does not receive a C-RP advertisement message;
default value is 150 seconds
priority Priority field value in the range 0–255 that the C-RP sends to the BSR
in C-RP advertisement messages. In the RP election process, the RP with the
lower priority value is preferred; default value is 192
interval Interval in the range 1–65535 seconds at which the C-RP sends
advertisement messages to the BSR; default value is 60 seconds