Link Failover Timeout - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

Chapter 12: L Commands

link failover timeout

link failover timeout failTime
Syntax
no link failover timeout
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies the time that the router waits for a port on a GE I/O module to become
Description
active before the router switches to the redundant port. The no version restores the
default setting, in which the router sets this time automatically.
failTime—Time that the router waits; in the range 100–10000 ms
Options
Interface Configuration
Mode
1227
link failover timeout