Ip Route-Type - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

ip route-type

For BGP:
Syntax
ip route-type [ unicast | both ]
no ip route-type
For IS-IS, OSPF, and RIP:
ip route-type [ unicast | multicast | both ]
no ip route-type
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies whether BGP, IS-IS, OSPF, or RIP routes are available only for unicast
Description
forwarding, only for multicast reverse path forwarding checks, or for both. The no
version restores the default value, unicast for BGP or both for IS-IS, OSPF, and RIP.
Options
Address Family Configuration (RIP), Router Configuration
Mode
unicast Specifies that routes for the protocol are available only for unicast
forwarding
multicast Specifies that routes for the protocol are available only for multicast
route path forwarding checks; this option is not available for BGP
both Specifies that routes for the protocol are available for both unicast
forwarding and multicast route path forwarding checks
Chapter 10: I Commands
933
ip route-type