Mpls Ldp Vpls Neighbor - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

mpls ldp vpls neighbor

[ no ] mpls ldp vpls vplsName neighbor ipAddress
Syntax
Command introduced in JUNOSe Release 8.2.0.
Release Information
Configures the remote VPLS edge (VE) device address of a neighbor in the VPLS
Description
domain in which the VPLS instance participates. The specified VPLS instance must
use LDP as the signaling protocol. If either or both LDP or MPLS are not configured
on the current virtual router, issuing this command creates the LDP and MPLS
configurations automatically. The no version deletes the neighbor from the VPLS
domain.
The mpls ldp vpls neighbor command is not valid for a VPLS instance that uses BGP
as the signaling protocol. To configure a VPLS instance with BGP signaling, use the
bridge vpls rd, bridge vpls route-target, bridge vpls site-name site-id, and bridge vpls
site-range commands.
Options
Global Configuration
Mode
Related Topics
vplsName Name of a VPLS instance created with the bridge vpls
transport-virtual-router command
ipAddress IP address of a neighbor in the VPLS domain
Configuring LDP Signaling for VPLS in the JUNOSe BGP and MPLS Configuration
Guide
Chapter 13: M Commands
1381
mpls ldp vpls neighbor