Member Interface - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

member interface

[ no ] member interface interfaceType interfaceSpecifier
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Adds a member VLAN or S-VLAN subinterface to a Martini layer 2 circuit associated
Description
with a load-balancing group. This command creates an MPLS shim interface and
associates it with the group. The no version removes the member subinterface from
the circuit. Repeat as needed to remove all member subinterfaces used by a
load-balanced circuit, thereby deleting the circuit from the group.
Options
L2 Transport Load-Balancing-Circuit Configuration
Mode
Related Topics
interfaceType One of the following interface types listed in Interface Types and
Specifiers on page 5
serial
pos
interfaceSpecifier—Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
Configuring CE-Side Load Balancing for Martini Layer 2 Transport in the JUNOSe
BGP and MPLS Configuration Guide
Chapter 13: M Commands
1311
member interface