Ip Vrrp Icr-Partition Group - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

ip vrrp icr-partition group

ip vrrp vrid icr-partition group partitionGroupingType
Syntax
Command introduced in JUNOSe Release 10.3.0.
Release Information
Configures the ICR partition to use either S-VLAN-based grouping or VLAN-based
Description
grouping for subscribers. If you specify VLAN as the grouping type or partition type,
the ICR partition consists of single-tagged VLAN-based subinterfaces. By default, the
ICR partition uses S-VLAN-based grouping. There is no no version.
Options
Interface Configuration, Subinterface Configuration
Mode
Related Topics
vrid VRID identifier; a number in the range 1–255
partitionGroupingType One of the following partition types:
svlan Configures the ICR partition to use double-tagged S-VLAN based
subinterfaces.
vlan Configures the ICR partition to use single-tagged VLAN based
subinterfaces.
Grouping ICR Subscribers Based on S-VLAN IDs
Grouping ICR Subscribers Based on VLAN IDs
Configuring an ICR Partition
Chapter 10: I Commands
ip vrrp icr-partition group
979