Table of Contents
Advertisement
Chapter 13: M Commands
numbers of MPLS packets received from the remote PE; any out of order packets
are dropped, regardless of whether sequencing is configured.
no-sequencing Specifies that the sequencing number in the control word is set
to zero, instructing the remote PE router to not attempt to detect out-of-order
packets; has no effect if no control word is sent in the packets.
relay-format ethernet Specifies that the router uses Ethernet signaling and
encapsulation, which causes the VLAN interface to appear as an Ethernet interface
to the other side of the connection; enables a VLAN interface on one side of an
MPLS tunnel to communicate with an Ethernet or a bridged Ethernet interface
on the other side of an MPLS tunnel. The VLAN tag is not included in the MPLS
encapsulation. This option is not available on serial or POS interfaces for HDLC
layer 2 circuits. It is available only on VLAN interfaces
relay-format frame-relay Specifies that the router uses legacy (pre-RFC 4619)
Frame Relay pseudowire type value for signaling and encapsulation. Enables a
router running JUNOSe software that supports the pseudowire type value defined
in RFC 4619, Encapsulation methods for transport of Frame Relay over MPLS
Networks, to interoperate with a router that uses the legacy (pre-RFC 4619)
pseudowire type value. This option is available on serial or POS interfaces for
Frame Relay layer 2 circuits. It is not supported on E120 and E320 routers.
relay-format ppp Specifies that the router uses VC-type PPP signaling and PPP
encapsulation instead of VC-type HDLC signaling and HDLC encapsulation. The
router uses VC-type HDLC signaling and HDLC encapsulation by default. This
option is available only on serial and POS interfaces for HDLC layer 2 circuits.
relay-format vlan Specifies that the router uses VLAN signaling and
encapsulation. This option is not available on serial or POS interfaces for HDLC
layer 2 circuits. It is available for VLAN interfaces.
Global Configuration
Mode
Configuring CE-Side Load Balancing for Martini Layer 2 Transport in the JUNOSe
Related Topics
BGP and MPLS Configuration Guide
1351
mpls l2transport load-balancing-group
Advertisement
Table of Contents
